Blackstone-NEY Ultrasonics is the leader in the fields of industrial and precision
ultrasonic cleaning equipment. We design and manufacture efficient, environmentally
sound solutions for tough part washer applications.
It seems that each advance in technology demands greater and greater attention to
cleanliness for its success.
As a result, the cleaning industry has been challenged to deliver the needed cleanliness
and has done so through rapid innovation over the past several years. Many of these
advances have involved the use of ultrasonic cleaning technologies utilizing multiple
frequency ultrasonic generators and advanced waveform ultrasonic generators.
These cutting edge ultrasonic cleaning technologies can remove sub-micron particles
from medical implants and silicon wafers alike.
The cleaning industry is currently in a struggle to replace solvent degreasing with
alternative "environmentally friendly" means of parts washing.
Although substitute water-based, aqueous degreasers, citrus degreasers and petroleum
based chemistries are available, they are often somewhat less effective as cleaners
than the solvents and may not perform adequately in some applications unless a mechanical
energy boost is added to assure the required levels of cleanliness.
Ultrasonic energy is now used extensively in critical cleaning applications to both
speed up and enhance the cleaning effect of the alternative chemistries.
For full details of the Blackstone-Ney range of products call us on 01274 668 267
We offer full installation and support with all our solutions.
We will assess your requirements then design and install the machine to the specification
Technical Support Line
For further specification and full product details please contact us on......
Ransohoff offer a wide variety of spray washers ranging from standard conveyor washers
to fully customized parts washer systems modified to tackle your most challenging
Spray technology is most effective when the application allows for “line of sight”
cleaning of all critical surfaces.
Direct impingement is very effective in removing gross levels of contaminant. Washers
using high pressure, in excess of 3,500 PSI, can effectively deburr machined aluminium
parts and pressures in the realm of 10,000 PSI can effectively deburr machined cast
Complicated parts with internal cavities and cross drilled holes are more difficult
to clean and typically require dedicated spray nozzles.
Pressure and, therefore, impingement, is drastically reduced when the solution is
expected to turn corners and fill large internal cavities. In applications such as
these, immersion and ultrasonic cleaning technologies will definitely outperform
a washer using spray technology alone.
For full details of the Ransohoff range of products call us on 01274 668 267